SW9 shock wave

1.Touch screen

2.Shockwave work handle jack

3.Function selecting knob & Confirming button

4.Accessory frame

5.Filter cup with pressure gauge

6.General power switch

7.Fuse holder

8.Power supply line switch

1.If you need to change adapters during operating, one hand hold the shockwave hand, the other hand use“U”shaped of combination wrench to get stuck flat bit of 3# adapter, screw it out by turning it to anticlockwise.

2. Choose 1# or 2# adapter, put it into screw cap, and than install then into shockwave handle. tighten by turning them to clockwise. Than use the“O”shaped wrench to fasten the adapter. Change adapter is finished.

3. When the number of times to reach 2 million, you need to replace the bullet iron pillar.

Remove the screw cap, and take out the old one. Then put into a new one and installed the adapter.

The shockwave system uses the ballistic principle of shockwave generation: A pressure wave is formed via a projectile by using accelerated compressed air. The compressed air is generated by an electronically-controlled ballistic-pressure compressor. Using elastic impact, the kinetic energy of the projectile is transferred into the probe of the applicator and then into the client's body. Consequently, during the treatment, the end of the applicator must be in direct-contact with the skin and subcutaneous tissue.

Shockwave is aimed at the affected areas that are the source of chronic pain. The influence of the shockwaves causes to the dissolution of calcium deposits and leads to better vascularization. The after-effect is relief from the pain.